Chemical Composition of Natural Hydrolates and Their Antimicrobial Activity on Arcobacter-Like Cells in Comparison with Other Microorganisms

Hydrolates obtained via the hydrodistillation and steam distillation of Lavandula angustifolia Mill., Syzygium aromaticum L., Foeniculum vulgare Mill., and Laurus nobilis L. were analyzed by gas chromatography with flame ionization detector (GC-FID) and gas chromatography coupled to mass spectrometry (GC-MS). Additionally, the hydrolates were evaluated for antimicrobial activity (disk-diffusion and microdilution method), influence on biofilm formation (Christensen method) and cytotoxicity of concentrated hydrolates against human cell lines (A549) by xCELLigence system. Using chemical analysis, 48, 9, 13 and 33 different components were detected in lavender, clove, fennel and laurel hydrolates, respectively. Lavender hydrolate contained the largest proportion of 1,8-cineol, linalool furanoxide, and linalool. The main components of laurel hydrolate were 1,8-cineol, 4-terpineol and α-terpineol. Fenchone and estragole were the most abundant in fennel hydrolate, and eugenol and eugenyl acetate in clove hydrolate. Concentrated hydrolates showed significant antimicrobial activity. Clove hydrolate was among the most antimicrobially active agents, most preferably against C. albicans, with an inhibition zone up to 23.5 mm. Moreover, concentrated hydrolates did not show any cytotoxic effect again8 st human A549 cells. In the presence of the non-concentrated hydrolates, significantly reduced biofilm formation was observed; however, with concentrated clove hydrolate, there was an increase in biofilm formation, e.g., of A. thereius, A. lanthieri, and A. butzleri. Research shows new findings about hydrolates that may be important in natural medicine or for preservation purposes.     

Structural and Thermodynamic Peculiarities of Core-Shell Particles at Fluid Interfaces from Triangular Lattice Models

A triangular lattice model for pattern formation by core-shell particles at fluid interfaces is introduced and studied for the particle to core diameter ratio equal to 3. Repulsion for overlapping shells and attraction at larger distances due to capillary forces are assumed. Ground states and thermodynamic properties are determined analytically and by Monte Carlo simulations for soft outer- and stiffer inner shells, with different decay rates of the interparticle repulsion. We find that thermodynamic properties are qualitatively the same for slow and for fast decay of the repulsive potential, but the ordered phases are stable for temperature ranges, depending strongly on the shape of the repulsive potential. More importantly, there are two types of patterns formed for fixed chemical potential—one for a slow and another one for a fast decay of the repulsion at small distances. In the first case, two different patterns—for example clusters or stripes—occur with the same probability for some range of the chemical potential. For a fixed concentration, an interface is formed between two ordered phases with the closest concentration, and the surface tension takes the same value for all stable interfaces. In the case of degeneracy, a stable interface cannot be formed for one out of four combinations of the coexisting phases, because of a larger surface tension. Our results show that by tuning the architecture of a thick polymeric shell, many different patterns can be obtained for a sufficiently low temperature.     

Multiplexed therapeutic drug monitoring of antipsychotics in dried plasma spots by LC‐MS/MS

In this work, a convenient method for the therapeutic monitoring of seven common antipsychotic drugs in “dried plasma spot” samples has been developed. It is based on the liquid chromatography tandem mass spectrometry technique, operating in multiple reaction monitoring mode, and a straightforward procedure for the simultaneous extraction of all antipsychotics in a single step, with high extraction yield. The method was fully validated with proper accuracy, precision, selectivity and sensitivity, for all the drugs. Limits of quantification were 0.12, 1.09, 1.46, 1.47, 5.70, 1.32, 1.33 µg/L for haloperidol, aripiprazole, olanzapine, quetiapine, clozapine, risperidone, and paliperidone, respectively. Accuracy, intra‐ and interday precision values were <10% for all drugs at all concentration levels examined. The method was tested in the analysis of 30 plasma samples from real patients for each drug. The proposed analytical approach, by combining practical and logistical advantages of microsampling with liquid chromatography tandem mass spectrometry analytical performance, could offer an ideal strategy for accurate and timely therapeutic drug monitoring of antipsychotic drugs in most clinical settings, even in remote centers and/or in out‐patient settings, bringing so many potential improvements in psychiatric patient care.     

Validated ecofriendly chromatographic method for quantitative determination of anti‐migraine quaternary mixture

A novel ecofriendly, cost and time saving high‐performance thin‐layer chromatographic method was developed and validated for simultaneous determination of metoclopramide, ergotamine, caffeine, and paracetamol in bulk and pharmaceutical formulation. The separation was carried out on silica gel plates, using ethyl acetate:ethanol:ammonia (9:1:0.1, v/v/v) as a developing system. Ultraviolet detection was carried out at 272 nm. The resulting retention times were 0.15, 0.36, 0.49, and 0.74 min for metoclopramide, ergotamine, caffeine, and paracetamol, respectively. The greenness profile assessment was achieved to the proposed method to evaluate its greenness characters to the environment with acceptable results. Validation parameters were checked according to International Conference of Harmonization guidelines to achieve the international requirements for quality control analysis of the proposed drugs.     

Modified layered bimetallic compound used as a novel adsorbent for the solid-phase extraction of monoaromatic hydrocarbons from water samples prior to gas chromatography–mass spectrometry

This study reports a promising method of solid-phase extraction for determining the toluene, ethylbenzene, p-xylene, m-xylene, o-xylene, 1,3,5-trimethylbenzene, and 1,2,4-trimethylbenzene in water samples by gas chromatography–mass spectrometry (GC–MS). Prior to this procedure, the magnesium–aluminum bimetallic hydroxides modified with sodium dodecylbenzenesulfonate (Mg/Al-SDBS-LDH) were prepared and served as the novel solid-phase extractant. The Mg/Al-SDBS-LDH has advantage of good hydrophobicity and larger spacing which facilitates the monoaromatic hydrocarbons (MAHCs) into the interlayer for adsorption. As a result, the seven MAHCs in 500 mL water samples were enriched greatly, and the theoretical enrichment factor reached to 125 times. Under the optimized conditions of solid-phase extraction (SPE) and GC–MS, the mass concentration of each MAHC (0.005–10, 0.01–10, or 0.05–10 ng/mL) had a fine linear relationship with peak area. The correlation coefficients were more than 0.995. The detection limits were between 0.001 and 0.01 ng/mL, and the RSD were between 3.1% and 6.6%. The method had been applied to determine the seven MAHCs in the Dongfengqu river water and laboratory wastewater of Chengdu University of Technology successfully.     

Applications of Tamm plasmon-liquid crystal devices

ABSTRACT

The Tamm-plasmon-polariton (TPP) occurs at the interface between a metallic film and the photonic-crystal (PC) substrate. Unlike conventional surface-plasmon-polariton (SPP), TPP can be directly excited by both the transverse electric (TE) and transverse magnetic (TM) electromagnetic waves without using additional coupling optics. The fact that the optical functionality of most plasmonics devices is determined after fabrication limits their applications. Tunable SPP devices by applying liquid crystals (LCs) have been widely demonstrated due to their large birefringence and easy controllability via external stimuli. However, actively tuning TPP is difficult because the localised electric field is between the metallic film and PC substrate, the change of refractive index above the metallic film has only small influences on TPP. This article is intended to briefly review recent progress towards using LCs for actively tuning TPP devices. Not only TPP devices can gain benefits from LCs, we will also discuss the applications of TPP for measuring the anisotropy of the alignment films of LC devices. The sensitivity of the proposed scheme will be discussed.     

Copper-immobilized ionic liquid as an alternative to organic solvents in the one-pot synthesis of bioactive dihydropyrano[2,3-c]pyrazole derivatives

In this study, a novel Cu-immobilized ionic liquid (IL)was designed, characterized, and employed as both promoter and solvent in the synthesis of some dihydropyrano[2,3-c]pyrazoles. The synthesized ionic liquid was characterized by ¹H NMR, ¹³C NMR, FTIR, ICP and EDX analysis and showed high catalytic activity to proceed the synthesis of bioactive dihydropyrano[2,3-c]pyrazole derivatives. This method has the advantage of using the IL as a green medium for the synthesize of the products in high to excellent yields within short reaction times.     

Synthesis of ionic liquid intercalated layered double hydroxides of magnesium and aluminum: A greener catalyst of Knoevenagel condensation

Due to their structural merits that arise from their stability and high surface area, the layered double hydroxide (LDH) materials have caused strong attention. These characteristics provided intriguing possibilities with improved efficiency for catalytic applications. In this work, the preparation of 1-butyl-3-methylimidazolium hydroxide ([BMIM]⁺OH⁻) intercalated by a facile approach in a layered double hydroxide (LDH) matrix is reported and its implementation as a greener catalyst is shown. Different physico-chemical techniques such as XRD, FTIR, TGA, and N₂-physisorption, HRTEM, and CO₂ adsorption are implemented to characterize the structure of the fabricated catalysts. The [BMIM]⁺OH⁻/LDH exhibit outstanding catalytic performance in Knoevenagel condensation, resulting from the high LDH surface area and synergistic effects between both the intercalated ionic liquid and LDHs matrix. Knoevenagel’s fabricated catalysts can be exploited to catalyze different condensations and can be reused well. This work therefore generates good opportunities in the field of catalysis for the preparing and implementation of LDH-based catalysts.     

Rapid qualitative profiling and quantitative analysis of Juglandis Mandshuricae Cortex and seven flavonoids by ultra-high performance liquid chromatography–quadrupole/orbitrap high-resolution mass spectrometry

Juglandis Mandshuricae Cortex is the bark of Juglans mandshurica Maxim., which has been used as a folk medicine plant in China and India. In this study, an ultra-high performance liquid chromatography–quadrupole/orbitrap high-resolution mass spectrometry method was developed to clarify and quantify the chemical profiling of Juglandis Mandshuricae Cortex rapidly. A total of 113 compounds were characterized. Among them, seven flavonoids were simultaneously quantified in 15 min, including myricetin, myricetrin, taxifolin, kaempferol, quercetin, quercitrin, and naringenin. The method was validated for accuracy, precision, and the limits of detection and quantification. All calibration curves showed a good linear relationship (r > 0.9990) within test ranges. The intra- and inter-day relative standard deviations were less than 2.16%. Accuracy validation showed that the recovery was between 95.6 and 101.3% with relative standard deviation values below 2.85%. The validated method was successfully applied to determine the contents of seven flavones in Juglandis Mandshuricae Cortex from seven sources and the contents of these places were calculated respectively. This method provides a theoretical basis for further developing the medicinal value of Juglandis Mandshuricae Cortex.     

Development and validation of a liquid chromatography–tandem mass spectrometry method for the simultaneous analysis of androgens,estrogens, glucocorticoids and progestagens in human serum

We present a liquid chromatography tandem mass spectrometry method for the simultaneous analysis of 16 endogenous steroids (androgens, estrogens, glucocorticoids and progestogens) in human serum. Samples (250 μl of matrix) were extracted with t-butylmethyl ether prior to LC–MS/MS analysis. The chromatographic separation was achieved on a reversed-phase column using a methanol–water gradient. The HPLC was coupled to a triple quadrupole mass spectrometer equipped with an electrospray ionization source with acquisition in multiple reaction monitoring mode. The method was validated using surrogate matrices and human serum samples. The specificity of the method was confirmed for all of the considered steroids; linearity was also assessed (R² > 0.99, lack-of-fit test) in the ranges of concentrations investigated. The lower limits of quantification were in the range 10–400 pg/ml depending on the target steroid. Accuracy was in the range 85–115% for all target steroids except for the lower limit of quantitation levels where it was 80–120%. The extraction recovery was always >65%. No significant matrix effects were observed. To test the reliability of the method, the analysis of serum samples collected from 10 healthy subjects (5 M/5F) was performed. The present method can be used to identify the trajectories of deviation from the concentration normality ranges applied to disorders of the gonadal and adrenal axes.